A study on the control of the printing accuracy in alumina parts by ceramic stereolithography

The printing accuracy in ceramic stereolithography is deteriorated by shrinkage due to photopolymerization of monomers and broadening owing to scattering of light. To improve the accuracy of printed alumina parts, a series of experiments involving the reduce of shrinkage and broadening were conducted. Firstly, the dependence of conversion of monomers , shrinkage of suspensions and warpage of parts on energy doses was quantitively investigated and correlated, with which the shrinkage was well controlled through optimization. Besides, the warpage problem was effectively resolved when adding 30 wt% PEG-200 in the suspensions to release the accumulated internal stress . Next, the broadening under different energy doses was observed and reduced by addition of absorbers, after which a self-defined parameter C d / W e was applied to suggest strategies in the selection of appropriate processing parameters and absorber content. On this basis, the holes with a diameter ranging from 50–200 μm were successfully printed.